PARTS, TOOLS, MATERIALS
- 6 -
YOU WILL NEED THE FOLLOWING TOOLS AND MATERIALS FOR THE
INSTALLATION:
Carton or other heavy material for covering the counter top.
If you have brick or masonry walls, you need special hardware and tools. Call the Sears Service Center for
instructions.
The ductwork you need for the installation is not included. All wall and roof caps must have a back-draft damper.
Clear tape
(for taping the templates to the wall)
Stud finder or thin nail.
Saber saw (for cutting vent holes for roof
or wall venting)
Phillips screwdriver (for the screws)
Pencil
Flat blade screwdriver (for the bolts)
Measuring tape (metal preferred)
Gloves
Key hole saw (for the power cord hole)
Electric drill
3/8" and 3/4" wood drill bits
1/2" and 3/16"
drill bits
Plumb line
Duct Tape
To Next Page
Loading...
