EasyManuals Logo

Kenmore W10323094A User Manual

Kenmore W10323094A
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
To dispense water and ice cubes together:
1. Select Cube. A light above the touch pad indicates your
selection.
2.
Press a sturdy container against the dispenser lever while
pressing the bottom touch pad on the dispenser control panel.
IMPORTANT: You do not need to apply a lot of pressure to the
lever in order to activate the dispenser. Pressing hard will not
make the water or ice dispense faster or in greater quantities.
3. Remove the container to stop dispensing.
A. Dispenser/ever
B. Removab/e tray
Dispenser Light
NOTES:
The dispenser lights are LEDs which should not need to be
changed.
When you use the dispenser, the lever will automatically turn
the light on. If you want the light to be on continuously, you
may choose either On or Auto.
Auto: The dispenser light will illuminate at half-power when the
light sensor detects the light levels in the room are low. To turn the
dispenser light on, press the light touch pad. The Auto indicator
light will illuminate.
On: For continuous light, press the light touch pad a second time.
The On indicator light will illuminate.
Off: To turn the dispenser light off, press the light touch pad a third
time.
Auto On
©
Dispenser Lock
The dispenser can be locked for easy cleaning or to avoid
unintentional dispensing by small children and pets.
NOTE: The dispenser lock does not shut off power to the product, to
the ice maker, or to the dispenser light. It just deactivates the
dispenser lever.
To lock and unlock dispenser:
Press and hold the lock/unlock touch pad for 3 seconds to lock the
dispenser. The indicator light will illuminate when Lock is on.
Press and hold the lock/unlock touch pad again for 3 seconds to
unlock dispenser. The indicator light will turn off.
Locked
W{ te ' F Sys@em
s
The water filter is located in the upper right-hand corner of the
refrigerator compartment.
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Water Filter Status
Indicator Models
The disposable water filter should be replaced when the
Replace light is lit, or at least every 6 months. If the water flow
to the water dispenser or ice maker decreases noticeably
before 6 months have passed, replace the water filter more
often.
After replacing the water filter, press and hold the Filter Reset
touch pad for 3 seconds until the Order or Replace light turns
off. See "Using the Controls."
Non-Indicator Models
The disposable water filter should be replaced at least every
6 months. If the water flow to the water dispenser or ice maker
decreases noticeably before 6 months have passed, replace the
water filter more often.
Replacing the Water Filter
IMPORTANT: Air trapped in the water system may cause water
and filter to eject. Always dispense water for at least 2 minutes
before removing the filter or blue bypass cap.
1. Turn the used water filter counterclockwise until it releases from
the filter mounting bracket.
2. Drain water from the water filter into the sink, and discard the
used water filter. Wipe up the excess water in the filter cover.
15

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kenmore W10323094A and is the answer not in the manual?

Kenmore W10323094A Specifications

General IconGeneral
BrandKenmore
ModelW10323094A
CategoryRefrigerator
LanguageEnglish

Related product manuals