Need help?Do you have a question about the Kenpro FM-240 and is the answer not in the manual?
Steps for powering on, setting squelch, selecting VFO mode, and tuning frequency using the dial and speed button.
Instructions on using the OFST button to work through a repeater and return to simplex mode.
Using the ENT button to enter commands for VFO settings like scan limits and step sizes.
Storing frequency, tone, scan mode, and duplex mode into memory channels.
Engaging the TNSQL button to mute the receiver speaker unless a correct tone is detected.
Addresses problems like no sound, frequency not staying, dialing issues, and scan failures.
Steps to re-initialize the CPU due to loss of backup voltage or incorrect settings.
To Next Page
General