4
TO REDUCE THE RISK OF INJURY TO PERSONS GROUNDING INSTALLATION
DANGER: Electric Shock Hazard Touching some of the internal components can
cause serious personal injury or death. Do not disassemble this appliance.
WARNING: Electric Shock Hazard Improper use of the grounding can result in
electric shock. Do not plug into an outlet until appliance is properly installed and
grounded.
CAUTION: Personal Injury Hazard
It is hazardous for anyone other than a competent person to carry out any service
or repair operation that involves the removal of a cover which gives protection
against exposure to microwave energy.
UTENSILS: See the instructions on "Materials you can use in microwave oven or
to be avoided in microwave oven." There may be certain non-metalic utensils that
are not safe to use for microwaveing. If in doubt, you can test the utensil in
question following the procedure below.
Utensil Test:
1. Fill a microwave-safe container with 1 cup of cold water (250ml) along with
the utensil in question.
2. Cook on maximum power for 1 minute.
3. Carefully feel the utensil. If the empty utensil is warm, do not use it for
microwave cooking.
4. Do not exceed 1 minute cooking time.
CLEANING
Be sure to disconnect the oven from the power supply.
1. Clean the inside of the oven after using with a slightly damp cloth.
2. Clean the accessories in the usual way in soapy water.
3. The door frame and seal and neighboring parts must be
cleaned carefully with a damp cloth when they are dirty.
This appliance must be grounded. In the event of an electrical short circuit, grounding
reduces the risk of electric shock by providing an escape wire for the electric current.
This appliance is equipped with a cord having a grounding wire with a grounding plug.
The plug must be plugged into an outlet that is properly installed and grounded.
Consult a qualified electrician or serviceman if the grounding instructions are not
completely understood or if doubt exists as to whether the appliance is properly
grounded. If it is necessary to use an extension cord, use only a 3-wire extension
cord.
1. A short power-supply cord is provided to reduce the risks resulting from
becoming entangled in or tripping over a longer cord.
2. If a long cord set or extension cord is used:
1) The marked electrical rating of the cord set or extension cord should be
at least as great as the electrical rating of the appliance.
2) The extension cord must be a grounding type 3-wire cord.
3) The long cord should be arranged so that it will not drape over the counter
top or tabletop where it can be pulled on by children or tripped over
unintentionally.
Three-round-pin plug
To Next Page
Loading...
