The re bricks in your Kent wood re are an important part of the appliance and helps ensure a
clean and efcient burn. However, re bricks are a consumable item and are designed to be
replaced as they are likely to degrade with use due to exposure to the extreme heat of the re.
The life of the re bricks will depend on what is burnt in the re and how hot the re usually burns
and also any damage sustained from wood not being positioned correctly.
At the risk of damaging the re box, re bricks should be replaced when they are damaged
enough that they no longer remain in place and cannot perform their intended function. Fire
bricks which are only cracked but still remain in place do not need to be replaced and are
safe to use.
KENT FIRE BRICKS
Dimensions (mm):
2 - 205 x 176 x 25
4 - 180 x 176 x 25
KWF299-7040
Rata & Logre II
KENT BAFFLES
Includes Promat bricks
Dimensions (mm): 480 x 200
KWF299-7043
(Top rear view)
Rata & Logre II
The bafe in your Kent wood re is an important part of the appliance and helps ensure a
clean, efcient and controllable burn. However, bafes and Promat bricks are a consumable
item and are designed to be replaced as they are likely to degrade with use due to exposure
to the extreme heat of the re.
The life of the bafe will depend on what is burnt in the re and how hot the re usually burns.
Replacing bafe:
1. Remove front air tube by pulling locking pin out of air tube spacer slide ring on the left top
side. Slide spacer ring to the right and slide air tube horizontally to the left. Right hand side
of the air tube will drop out of the keyed side.
2. Swing air tube out through door.
3. Lift bafe plate up off side support rails and pull forward 40mm. Push one side up as high as
you can while letting the other side drop over the side support rail.
4. Keep at a 30° angle and remove it through the door.
5. Reverse process to install new bafe. And air tube.
6. Ensure bafe is sitting rm against back.
NOTE: For all other re parts please contact your Kent dealer.
14
To Next Page
Loading...
