Need help?Do you have a question about the Kenwood KAC-524 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Signal to Noise Ratio | 100 dB |
| THD at RMS Power | 0.08% |
| Speaker Level Inputs | Yes |
| Preamp Outputs | Yes |
| Bridged RMS Power at 4 Ohms | 150 Watts |
| Built-in Crossover | LP/HP |
Details audio performance parameters like power output and frequency response.
Outlines general specifications such as operating voltage, dimensions, and weight.
Critical safety warnings to prevent fire and personal injury during operation.
Important cautions to maintain the unit in proper working order and prevent damage.
Lists included accessories for the amplifier unit.
Important safety notes regarding installation to prevent damage or hazards.
Details a monaural high-power setup using the amplifier.
Explains setting up a high-power stereo system with two amplifiers.
Advises on speaker impedance to avoid amplifier damage in high power configurations.
Connects the ground cord of an RCA cable to the designated terminal.
Selects the amplification method for input signals (STEREO or L+R).
Adjusts input sensitivity based on the center unit's pre-out level.
Explains frequency band division using coils and capacitors for subwoofer integration.
Provides formulas to calculate necessary coil and capacitor values for the system.
Illustrates a Tri-mode configuration setup with the OPERATION switch.
To Next Page
