To Next PageTo Next Page
Need help?Do you have a question about the Kenwood KAF-1030 and is the answer not in the manual?
General| Input sensitivity (MM) | 2.5mV |
|---|---|
| Signal to noise ratio (MM) | 86dB |
| Frequency response | 5Hz to 100kHz |
| Total harmonic distortion | 0.008% |
| Speaker load impedance | 4Ω to 16Ω |
Lists included accessories for the amplifier.
Procedure to reset the microcomputer in case of malfunction.
Indicates standby status for KAF-3030R.
Switches the unit ON or OFF.
Selects speaker systems A and/or B.
Adjusts low frequencies.
Adjusts high frequencies.
Adjusts volume balance between left and right.
Adjusts the volume.
Mutes the sound temporarily.
Emphasizes deep bass sounds.
Receives signals for remote control.
Port for headphone listening.
Enables high-quality sound listening.
Enables Advanced Digital Audio source.
Selects input sources.
Indicates the selected input source.
Controls CD player functions.
Controls MD recorder functions.
Selects input sources on the remote.
Switches power ON/STANDBY.
Skips discs on the Autochanger CD player.
Operates cassette deck functions.
Operates tuner functions.
Mutes sound temporarily.
Adjusts the volume.
Switches SOURCE DIRECT ON/OFF.
Switches Adv. DA / CD DIRECT ON/OFF.
Details of microprocessor pin functions and signals.
Procedure to adjust idle current.
Procedure to adjust DC offset.
Replace safety-critical components with recommended parts.
Check insulation and leakage current before returning to customer.
Note that measurements may vary based on instruments.
Details output power at different impedances.
Details effective output power ratings.
Measures distortion levels at various frequencies.
Details frequency range and response.
Specifies input sensitivity and impedance for various sources.
Describes tone control characteristics.
Lists power consumption and dimensions.
Lists Kenwood service center locations worldwide.
