Do you have a question about the Kenwood KDC-135 and is the answer not in the manual?
frequency range (200kHz space) | 87.9MHz~107.9MHz |
---|---|
usable sensitivity (S/N=30dB) | 9.3dBf (0.8µV/75Ω) |
quieting sensitivity (S/N=50dB) | 15.2dBf (1.6µV/75Ω) |
frequency range (10kHz space) | 530kHz~1700kHz |
---|---|
usable sensitivity (S/N=20dB) | 28dBµ (25µV) |
spindle speed | 500~200rpm (CLV) |
---|---|
frequency response (±1dB) | 10Hz~20kHz |
total harmonic distortion (1kHz) | 0.01% |
maximum output power | 50W x 4 |
---|---|
speaker impedance | 4~8Ω |
preout level / load (during disc play) | 2000mV/10kΩ |
operating voltage | 14.4V |
---|---|
current consumption | 10A |
weight | 3.1lbs (1.40kg) |
frequency range (50kHz space) | 87.5MHz~108.0MHz |
---|---|
usable sensitivity (S/N=30dB) | 9.3dBf (0.8µV/75Ω) |
quieting sensitivity (S/N=50dB) | 15.2dBf (1.6µV/75Ω) |
frequency range (9kHz space) | 531kHz~1611kHz |
---|---|
usable sensitivity (S/N=20dB) | 28dBµ (25µV) |
spindle speed | 500~200rpm (CLV) |
---|---|
frequency response (±1dB) | 10Hz~20kHz |
total harmonic distortion (1kHz) | 0.01% |
maximum output power | 45W x 4 |
---|---|
speaker impedance | 4~8Ω |
preout level / load (during disc play) | 2000mV/10kΩ |
operating voltage | 14.4V |
---|---|
current consumption | 10A |
weight | 3.1lbs (1.40kg) |
Follow precautions to prevent injury, fire, and machine damage.
Turn the unit ON/OFF and adjust volume using SRC and VOL knob.
Select audio source via SRC and quickly lower volume using ATT.
Follow steps for safe installation: disconnect battery, connect wires, and secure unit.
Connect wires correctly to power sources; insulate wires to prevent shorts.
Connect power, ACC, ignition, and control wires to appropriate terminals.
Connect speaker wires (front/rear) to their corresponding terminals.
Use metal mounting strap and self-tapping screws for installation.
Align unit with bracket and secure with accessory screws; note screw usage.
Address problems with switching sources, System Q, or subwoofer output.
Troubleshoot CDs not playing, poor radio reception, or touch sensor tone.
Interpret error codes (E-04, E-99, DCER) and system status (IN Blink).