KDC-C717
KDC-C667
COMPACT DISC AUTO CHANGER
INSTRUCTION MANUAL
©B64-1801-20 (MW)
Troubleshooting Guide
Specifications
Specifications subject to change without notice.
Laser diode ..................................................................................................GaAlAs (λ=780 nm)
Digital Filter ..............................................................................................8 Time Over Sampling
D/A Converter.......................................................................................................................1 bit
Spindle speed.............................................................................................500 ~ 200 rpm (CLV)
Wow & Flutter......................................................................................Below Measurable Limit
Frequency Response (±1 dB)...............................................................................5 Hz ~ 20 kHz
Total harmonic distortion (1 kHz) ...................................................................................0.005 %
Signal to Noise Ratio........................................................................................................100 dB
Dynamic range ...................................................................................................................94 dB
Channel separation.............................................................................................................96 dB
Operating voltage...........................................................................14.4 V (11 ~ 16 V allowable)
Current consumption ................................................................................0.8 A at Rated power
Dimensions (W × H × D)
(KDC-C717)........................................250 × 80 × 176 mm (9-13/16 × 3-1/8 × 6-13/16 in.)
(KDC-C667)........................................250 × 64 × 176 mm (9-13/16 × 2-1/2 × 6-13/16 in.)
Weight (KDC-C717) ............................................................................................2.0 kg (4.4 LBs)
Weight (KDC-C667) ............................................................................................1.8 kg (4.0 LBs)
When removing the CD changer, be sure to first eject a magazine then unplug the changer cord. Do
not forget to attach the transport screws before transporting the CD changer.
The CD changer may be damaged during transport if a magazine or CD is left inside it or the transport
screws are not attached.
PROBLEM
POSSIBLE CAUSE SOLUTION
Sound skips due to vibra-
tion.
The disc changer mode
cannot be selected.
• The unit is mounted at a slant.
• Changer unit is mounted in an
unstable place.
• The angle adjustment switches
are set improperly.
The O-N selection switch of the
disc changer is not set properly.
• Mount the unit so that is level.
• Mount the unit in a stable place.
• Set the angle adjustment
switches to the correct posi-
tions.
Set the O-N selection switch to
"O" position.
To Next Page
Need help?
General
