Kenwood KVT-532DVD Service Manual

This product uses Lead Free solder.
This product complies with the
RoHS directive for the European market.
© 2008-3 PRINTED IN JA PAN
B53-0621-00
(
N
)
519
SERVICE MANUAL
KVT-50DVDRY/512/522DVD
MONITOR WITH DVD RECEIVER
/522DVDY/532DVD/532DVDM
OFF
OPEN
/CLOSE
TEL
SCAN
MONITOR WITH DVD RECEIVER
V.OFF
SRC NAV
SF
KVT-522DVD
ATT
AUTO
+FM
VOLUME
EJECT
TI
Illustrations is KVT-522DVD
Remote controller *
(A70-2083-15)
RC-DV340
Escutcheon
(B07-3159-02)
Mounting hardware assy
(J21-9716-03)
Lever
(D10-4589-04) x2
Screw set *
(N99-1758-15)
SIZE AAA BATTERY *
(NOT SUPPLIED)
DC cord *
(E30-6815-05)
DC cord *
(E30-6816-05)
Cord with plug
(E30-6813-05)
* Depends on the models. Refer to the parts list.
REV: 5m
PRK: 2m
BU,GND: 1m
The IC3, and IC11 in the DVD unit (X37-1100-03) are not replaceable components.
When these ICs are defective, replace the whole DVD mechanism assembly (X92-6160-00).
You cannot replace only the board.
TEST MODE is the same as DDX512.
Please refer to the service manual (DDX512: B53-0620-00).

Kenwood KVT-532DVD Specifications

General

Resolution	800 x 480 pixels
DVD Playback	Yes
Bluetooth	Yes
USB Input	Yes
Audio Output Power	50 watts x 4 channels
Preamp Outputs	3 Pairs (Front, Rear, Subwoofer)
Touchscreen	Yes
iPod Control	Yes
Preamp Voltage	4 volts
CD Player	Yes
AM/FM Tuner	Yes
GPS Navigation	No
Rear View Camera Input	Yes
Steering Wheel Control	Yes
Equalizer	13-band
RMS Power Output	22 watts
Peak Output	50 watts