Kenwood L-A1 User Manual

The balance input terminals
TT
The GND (ground) terminal
The GND cord of the record player should be
connected here.
The balance terminals provide a professional
connection method for use at broadcast sta-
tions and in other professional applications.
These terminals may be used for connecting
any equipment with output balance terminals.
To connect your equipment, use either com-
mercially available cables or the Canon ca-
bles that come with your equipment. The end
of the Canon cable without a lock switch is the
end which should be connected to the input
terminal (i.e., balance terminal) of the am-
plifier.
To remove the input terminal from the am-
plifier, press the terminal release lever while
removing the plug.
b=
¢
Insert
the
connecting
cords
firmly
into
their
sockets.
Inserting
these
cords
loosely
may
result
in
noise
or
the
loss
of
sound
altogether.
e
When
inserting
or
removing
the
connecting
cords,
aiways
be
sure
to
first
remove
the
power
cord
from
its
socket.
Inserting
of
removing
the
connection
cords
with
the
power
cord
in
its
socket
may
result
in
the
faulty
operation
of
or
damage
to
the
amplifier.
¢
Donot
connect
any
equipment
with
specified
power
requirements
in
excess
of
the
maximum
power
displayed
above
the
socket
on
the rear
of
the
unit.
How to connect the speakers
Connect the speakers in such a way that the core of the wire does not come into contact with any
terminal other than the speaker terminal.
Prepare the wire for Loosen the
é Ei Insert the speaker
connection. terminal cap.
EB Tighten the
wire.
terminal cap.
20mm
= a / my, (SLI
ae.
g
X SX
(Remove the covering to
expose the core of the
wire.)
Speaker impedance
Use speakers with an impedance from 4 to 16 Q. Under no circumstances should you use speakers
with an impedance less than 4 Q.
° Crossing the jeft and right terminals, or inserting the plus and minus terminals incorrectly may result in muddled sound
where instruments cannot be heard clearly, or in an unnatural, monotone sound. Please be sure to connect the speaker
wires correctly.
¢ Do not cross the plus and minus (+ or -) or left and right (L or R) terminals when connecting the speaker cords.

Kenwood L-A1 Specifications

General

Brand	Kenwood
Model	L-A1
Category	Amplifier
Language	English