Need help?Do you have a question about the Kenwood NX-1200 Series and is the answer not in the manual?
General| IP Rating | IP54/55 |
|---|---|
| Operating Temperature | -30°C to +60°C |
| Frequency Range | 136-174 MHz |
| Power Output | VHF: 5W/1W, UHF: 4W/1W |
| Channel Spacing | 12.5 kHz, 25 kHz |
| Modulation | 16K0F3E, 11K0F3E |
Information on the transceiver's firmware version and programming software.
Displays the battery voltage value of the transceiver when it is turned ON.
Protects the transceiver from unauthorized usage by requiring a password.
Transmits audio by speaking into the microphone without pressing the PTT switch.
Initiates a voice call to a target transceiver individually by specifying a Unit ID.
Acquires current location information using GPS signals.
Remotely operates and controls a specified transceiver using radio communication.
Sends an Emergency Alarm before entering Emergency Mode to notify the base station.
Adjusts transmit and receive capabilities using KPG-D6/D6N.
Initiates a voice call to a target transceiver individually by specifying a Unit ID.
Acquires current location information using GPS signals.
Time from finishing reception until transceiver resumes Site Roaming.
Displays the battery voltage value of the transceiver when it is turned ON.
Restricts transmission to prevent interference with other communications on busy channels.
Protects the transceiver from unauthorized usage by requiring a password.
Acquires current location information using GPS signals.
Remotely operates and controls a specified transceiver using radio communication.
To Next Page
