Need help?Do you have a question about the Kenwood NX-1800D and is the answer not in the manual?
General| Brand | Kenwood |
|---|---|
| Model | NX-1800D |
| Category | Transceiver |
| Language | English |
Step-by-step guide for connecting the transceiver's power cable to the vehicle's power source.
Instructions on securely mounting the transceiver using the provided bracket and screws.
How to turn the transceiver on and off using the power switch.
Method for increasing or decreasing the audio volume.
Procedure for navigating between zones and selecting channels.
Steps to initiate a group call using NXDN or DMR protocols.
How to receive group calls in NXDN and DMR systems.
How to receive individual calls in NXDN and DMR systems.
Specifies a Group ID to send status messages.
Allows jumping to a pre-programmed home channel.
Specifies an Individual ID to send status messages.
Accesses and performs functions via the transceiver menu.
Starts or stops scanning channels for signals.
Enables or disables audio scrambling or data encryption.
Sends short text messages such as addresses or phone numbers.
Sends status messages selected from a list.
Enters password mode to unlock the transceiver.
How to enter and confirm the transceiver password to unlock it.
Temporarily removes channels from the scanning sequence.
Defines the channel selected after scan transmission.
Steps to make a DTMF call using manual dialing or keypad.
Disables a transceiver remotely if it is stolen or lost.
How to switch to secure or encrypted transmission mode.
Procedure to select or change the scrambler code.
Filters calls based on matching tone or code for clearer communication.
Filters calls based on matching RAN for digital communications.
Makes a voice call to a station or group of stations using 5-tone signaling.
Prevents extended transmission on a channel by stopping transmission.
To Next Page