9
4 How it works
A powerful ultrasonic wave scares the animals.
If animals wander into the PIR sensor's detection range, the wave is emitted. This alarms
the animals, causing them to leave the area.
A powerful LED flash startles the animals.
If animals wander into the detection range, a flash is generated. This scares the animals and
causes them to flee.
There is also a warning sound to scare wild animals.
5 Setup and commissioning
1. Open the battery compartment on the back; insert 3 rechargeable type AA batteries and close
the battery compartment.
(Batteries are included in the scope of delivery)
2. Position the product in the direction of the area to be protected (e.g. in the flower bed or against
a wall, etc.).
3. When choosing a position, ensure that the solar panel on the top is able to absorb as much
sunlight as possible.
4. If you want to set the device up on the ground, secure it adequately into the soil using the
ground spike. Drill a hole first to avoid potential damage.
5. The device can be secured in the ground using the ground spike, mounted on a wall or
positioned directly on the ground surface.
6 Settings
"Sensitivity" rotary dial (left):
Setting the sensitivity and range. Turn the rotary dial clockwise to increase the range.
"Frequency" rotary dial (right):
To control the frequency. Turn the rotary dial clockwise to increase the frequency.
The frequency settings are described below:
0 Off
1 13.5 kHz-19.5 kHz drives away mice, rats, dogs, foxes, martens, etc.
2 19.5 kHz-24.5 kHz drives away cats, raccoons, badgers, skunks, etc.
3 24.5 kHz-45.5 kHz drives away bats, birds, rodents, etc.
4 Alarm sound and LED flash scares wild animals
5 13.5 kHz-45.5 kHz and LED flash Universal setting for driving away all potential
unwanted animals
To Next Page
Loading...