ADB-BA-e-1510 15
6.4 Electric power supply
Select a country-specific mains plug and plug it into the mains adapter.
Check, whether the voltage acceptance on the scales is set correctly.
Do not connect the scales to the power grid unless the information on
the instrument (sticker) matches the local mains voltage.
Only use KERN original mains adapter. Using other makes requires
Important:
Prior to commissioning check the mains cable for damage.
Make sure that the mains adapter will not be in touch with liquids.
The mains plug must be accessible at any time.
Connect the mains adapter to the connecting socket on the backside of
the balance and to the power mains.
The display unit lights up.
As soon as the balance is supplied with energy,
the indicator [ ] is displayed.
6.5 Initial Commissioning
In order to obtain exact results with the electronic balances, your balance must have
reached the operating temperature (see warming up time chap. 1). During this
warming up time the balance must be connected to the power supply (mains,
accumulator or battery).
The accuracy of the balance depends on the local acceleration of gravity.
Strictly observe hints in chapter Adjustment.
6.6 Connection of peripheral devices
Before connecting or disconnecting of additional devices (printer, PC) to the data
interface, always disconnect the balance from the power supply.
With your balance, only use accessories and peripheral devices by KERN, as they
are ideally tuned to your balance.
To Next Page
Loading...
Need help?
General
