EN
32
Location
The appliance should be installed well away from sources of heat such as radiators,
boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the
cabinet. To ensure best performance, if the appliance is positioned below an overhan-
ging wall unit, the minimum distance between the top of the cabinet and the wall unit
must be at least 100 mm. Ideally, however, the appliance should not be positioned
below overhanging wall units. Accurate leveling is ensured by one or more adjusta-
ble feet at the base of the cabinet.
Warning!
It must be possible to disconnect the appliance from the mains power sup-
ply; the plug must therefore be easily accessible after installation.
Electrical connection
Before plugging in, ensure that the voltage and frequency shown on the rating plate
correspond to your domestic power supply. The appliance must be earthed. The power
supply cable plug is provided with a contact for this purpose. If the domestic power
supply socket is not earthed, connect the appliance to a separate earth in compliance
with current regulations, consulting a qualied electrician.
The manufacturer declines all responsibility if the above safety precautions are not ob-
served. This appliance complies with the E.E.C. Directives.
INSTALLATION
Positioning
Install this appliance at a location where the ambient temperature corresponds to
the climate class indicated on the rating plate of the appliance:
Climate class Ambient temperature
SN +10
o
C to +32
o
C
N +16
o
C to +32
o
C
ST +16
o
C to +38
o
C
T +16
o
C to +43
o
C
To Next Page
Loading...
