5
2.2 Unpacking
Save all major packing materials for repackaging should re-shipment be required.
The following tools are required to unpack the printer:
Diagonal cutters
2.5 mm ball hex key wrench
3 mm ball hex key wrench
Adjustable open end wrench, or
3/4" open end wrench
9/16" open end wrench
WARNING
This procedure requires three people to properly
unpack the printer.
1. Locate the pallet in a location with sufficient room to vertically remove the carton
and to roll the printer down the loading ramps.
2. While holding the ramps against the packing carton, cut the shipping straps and
lower the ramps to the floor.
3. Cut the remaining shipping straps.
4. Vertically remove the shipping carton and the protective vinyl bag.
5. Open the paper compartment and remove the ramp supports, mounting hardware,
lifting levers, and rachet wrench.
6. With the ratchet wrench install the ramp supports to the underside of the ramps
with the mounting hardware.
7. From under the pallet, loosen the nuts securing the four J-hooks and disengage
the hooks from the corners of the printer cabinet.
8. Raise the ramps and remove the three lag bolts securing the printer shipping
support. Return the ramps to the lowered position.
9. Place the two lifting levers across the pivot board at position 1 with three inches
of the lever under the printer (mark A).
10. While two people step on the levers to raise the printer, a third person can remove
the shipping support.
Mantenimiento Periféricos Informáticos SL C/Canteras, 15 28860 Paracuellos de Jarama Tel: 00 34 917481604 WEB: https://mpi.com.es
To Next Page