TW2000 WOOD–FIRED BOILER – INSTRUCTION MANUAL
TW2000 7 Jan-08
1.8 HOMEOWNER CHECKLIST
a) Keep area around TW2000 boiler clean and clear of combustibles.
b) Use only dry wood. DO NOT burn garbage, gasoline, naphtha engine oil or any other
combustible liquid.
c) Remove ashes as directed.
d) Watch for soot in smoke pipe – clean regularly.
e) Clean Boiler heat exchanger regularly.
f) Be aware of danger due to overfiring unit.
g) Do not load above maximum loading level (middle of loading door) or overheating may
result.
h) This unit is NOT suitable for automatic stoking.
i) Load carefully. Do not slam fuel against rear or sides of firebox. This may damage the
brick lining. See fig. TW-7 to order and install replacement firebrick.
j) Always observe the following minimum clearances to combustible materials – Front 48”
(1220 mm); one side 6” (152 mm); opposite side and rear 24” (610 mm); and flue pipe 18”
(465 mm) and the floor must be non-combustible.
k) Do not store solid fuel within the above clearances or within the space required for
charging and ash removal.
l) Keep firing door closed and maintain seals in good condition.
m) Establish a routine for storage of fuel, care of the appliance, and firing techniques.
To Next Page
Loading...
Need help?
General
