Kesseböhmer CLIMBER User Manual

 






 !"
##









 




Kesseböhmer CLIMBER Specifications

General

Movement	Vertical
Control	Remote Control
Material	Aluminum
Height Adjustment	Yes
Mounting Type	Wall Mounted

Summary

General Safety Principles

Key Safety Information

Crucial safety instructions for installation, operation, and maintenance.

Specific Safety Guidelines

Child Safety Precautions

Safe Cleaning Procedures

Drive Unit and Sensor Field Care

CLIMBER Operation Overview

Opening the Slat Lifter

Step-by-step instructions for opening the CLIMBER slat lifter attachment.

Closing the Slat Lifter

Step-by-step instructions for closing the CLIMBER slat lifter attachment.

Safety Switch-off Functions

UP Direction Safety Switch-off

DOWN Direction Safety Switch-off

Device Reset and Position Configuration

Factory Settings Reset (Type 01)

Procedure to reset the device to original factory settings, clearing saved positions.

Setting Top End Position

Instructions for defining the maximum upward travel limit of the slat suspension.

Setting Bottom End Position

Instructions for defining the maximum downward travel limit of the slat suspension.

Programming Intermediate Positions

Advanced Reset and Teaching-in Procedures

Initial Teaching-in Phase

The sequence for setting end positions during initial setup or after a reset.

Setting UP Travel Endpoint

Detailed steps for configuring the upper limit of the slat movement.

Setting DOWN Travel Endpoint

Detailed steps for configuring the lower limit of the slat movement.

Teaching-in Pulling Force

Programming Intermediate Position (Post-Reset)

Intermediate Position Management and Reset Options

Adjusting Intermediate Position

Full Settings Reset (Reed Contact)

Partial Settings Reset (Retain Intermediate)