Kestrel
®
4000 Pocket Weather
™
Tracker
™
Quick Start
Insert the 2 AAA batteries as indicated on the battery door.
After the Introduction Screen appears for 3
seconds, the Date/Time Setup Screen will
appear. Set the correct date and time using
and to adjust, and and to scroll.
Press to exit the Date/Time Setup.
Press again to exit the Main Menu.
The Date and Time Screen will appear.
Press to scroll to the Current Wind Speed
Screen.
Press to scroll to the Current Temperature
Screen.
Continue pressing for current readings of: Wind Chill,
Humidity, Heat Index, Dewpoint, Wet Bulb Temperature,
Barometric Pressure, Altitude, Density Altitude, and User
Screens 1, 2 & 3. (User Screens show three measurements of
your choice and are defined in setup. See pages 8 and 10 of the
instruction manual for more information.)
Press to scroll through these screens in reverse order.
While viewing any of the Current Measurement
Screens, press to view the Min/Max/Avg for
the measurement. If there is no stored data,
--.- will appear.
Press to view the Chart Screen for the
measurement. If there is no stored data, the
axis will appear but the chart will be blank.
The factory setting for stored data, to be displayed on the
Min/Max/Avg and Chart screens, is once per hour. (See page 9
to change the stored data interval.)
Press to return to the Min/Max/Avg and Current Screens. From
either Min/Max/Avg or Chart Screen, press or to see
Min/Max/Avg or Chart Screen for the other measurements.
To Next Page
Need help?
General
