Kettler DINING TABLE 2610 User Manual

3.
2610 36” x 72” DINING TABLE
Contents:
(4) Legs
(2) Side Braces
(2) Table feet
(1) Table Top
(16) 1/4 - 20 x 2 1/2” Bolts
(4) 1/4 - 20 x 3” Bolts
Tool Required:
#3 Phillips Head Screwdriver
Assembly Instructions
1.
With the curved side facing out
align the table leg with the predrilled hole
on the foot of the table and insert a 1/4 -
20 x 3” bolt then tighten with the phillips
screwdriver.
Repeat on the other end, do both sets.
1.
Align the predrilled holes on the leg
with the metal insert on the frame,
insert the bolt.
2.
Place the leg with foot
inside the frame underneath the
tabletop. Align the predrilled
holes, insert two 14 - 20 x 2 1/2”
bolts then tighten them with the
phillips screwdriver.
Repeat on the other leg, do both sides.
3.
Place the side support braces
vertically between the legs aligning the
predrilled holes. Insert two 1/4-20 x 2 1/2”
bolts thru the hole into the center brace then
tighten them with the phillips screwdriver.
Repeat on the other brace, do both sides.
2.
Made in the U.S.A.
www.kettlerusa.com
info@kettlerusa.com
Copyright © Kettler USA 309.01

Kettler DINING TABLE 2610 Specifications

General

Brand	Kettler
Model	DINING TABLE 2610
Category	Indoor Furnishing
Language	English

Summary

Assembly Instructions

Attach Legs to Table Feet

Align leg with foot, insert 1/4-20 x 3" bolt and tighten. Repeat for all legs.

Secure Leg Assembly to Tabletop

Place leg inside frame, align holes, insert two 1/4-20 x 2 1/2" bolts and tighten.

Install Side Support Braces

Vertically place braces between legs, align holes, insert two 1/4-20 x 2 1/2" bolts into center brace and tighten.

Product Care and Maintenance

Cleaning Instructions

Clean with soap and warm water. Use a soft brush for tough stains. Rinse hardware in coastal areas.

Kettler Limited Warranty

Warranty Coverage and Exclusions

20-year residential/5-year commercial warranty for defects. Excludes hardware, misuse, and acts of nature.