Kewtech KEW80L User Manual

KEW80L
Bluetooth direct label printer
USER GUIDE
DETAIL LAYOUT
PRINTER STATUS OPERATION
Power On Press the power key for 3s
Power Off Press the power key 2 times
Function
Select
After starting the printer press and hold the power key for 5
seconds, then release. Further presses of the power key selects
the category. Pressing the paper feed key selects the sub-category.
DEVICE SPECIFICATION
LABEL ROLL INSTALLATION BATTERY INSTALLATION
CHARGING YOUR PRINTER
1. Press the cover release button to open the top cover.
2. Ensurethattheleft-handspacerisinplaceasshowninrstpicture.
3. Load the label roll against the left-hand spacer and with the labels facing
forwards.
4. The right-hand adjustable spacer needs to be set to keep the labels in
line. To release the adjustable spacer’s lock, pull the green lever forward
- second picture – do not use excessive force. With the spacer now
freetomove,slideittobeasnugtwiththeright-handsideofthe
labels. Now, push the green lever backwards until it clicks.
5. Pull one label out of the printer and then close the lid ensuring that it
snaps into its catch.
1. When installing or replacing a battery make sure that the printer is
switched off.
2.Toinstallabatteryforthersttime,removetheprotectiveadhesivestrip
over the battery terminals.
3. Insert the battery into the compartment in the rear of the printer by
placingtheedgeoppositethecatchinrst.Then,pushthecatchintoplace
until it snaps closed.
4. To remove a battery, ensure that the printer is turned off, then do the
reverse of point 3 above.
Your KEW80L is supplied with a power supply unit with the correct
technicalspecicationtochargeyourprinter’sbattery.Onlyusethis
power supply to charge the printer.
Only use the charging interface socket on the printer to charge the
battery. Putting power to the USB Socket will NOT charge the battery.
Important - Never leave the printer unattended while charging.
Print Mode Thermal Line Printing
Paper Width 58mm
Print Density 84 dot / line
Print Speed 50 - 90mm/s
Interface USB + Bluetooth
Resolution 203dpi
Roll Diameter 50mm
Paper Thickness 0.06-0.08mm
Print Command ESC / TSPL
Character Size 24*24 point
Input Buffer 256k bytes
Power Adapter Input AC 100-220V; Output DC9V / 1A
Lithium Battery 1200mAh/7/4V
Charging Time 4 hours
Bar Code Type UPC-A, UPC-E, JAN13 (EAN1), JAN8 (EAN8),
CODE39, CODE93, CODE128,QR CODE
Operating System Android, IOS, PC(Windows)
Working Environment Temperature 0°C ~ 50°C; humidity 20% ~ 85%
Storage Environment Temperature -20°C ~ 60°C; humidity 5% ~ 95%
Power Key
Paper Feed Key
Charging Port
USB Port
OLED Screen
Cover
Release Button
Hook
Battery Clip
Right-hand
adjustable
spacer
Left-hand
Spacer

Kewtech KEW80L Specifications

General

Brand	Kewtech
Model	KEW80L
Category	Label Maker
Language	English