Need help?Do you have a question about the Key Digital KD-X222PO and is the answer not in the manual?
General| Category | Extender |
|---|---|
| Model | KD-X222PO |
| Video Bandwidth | 18 Gbps |
| HDCP Compliance | HDCP 2.2 |
| Power over HDBaseT (PoH) | Yes |
| IR Pass-through | Yes |
| RS-232 Pass-through | Yes |
| PoE Support | Yes |
| Audio Support | Dolby TrueHD, DTS-HD Master Audio |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -20°C to 60°C |
| Humidity | 10% to 90% (non-condensing) |
Enables sending and receiving bi-directional RS-232 control signals up to 115,200bps.
Provides control of Tx units and shows connectivity status.
Allows updating firmware for MCU or HDBaseT units.
Details on obtaining or fabricating RS-232 cables.
Describes the Tx unit's IR In port for hardwired serial IR connections.
Connects IR sensors directly to the Rx unit's IR In port.
Pass-through signal for IR In port or RS-232, powered by 5V.
Details about the included IR Sensor and IR Emitter compatibility.
Indicates power status: solid green for healthy, steady blink for inadequate power or connectivity issues.
Blue light indicates active HDMI signal reception or Hot Plug Detection voltage.
Blue light indicates active link and Hot Plug Detection voltage between units.
Specifies connection parameters: Baud Rate 57600, 8 Data Bits, 1 Stop Bit, None Parity/Flow Control.
Command to retrieve system status information, including firmware version and connectivity.
Lists available commands for system control, including help, status, and configuration.
Details inputs, outputs, signal capabilities, connectors, and physical specifications.
Covers regulatory compliance, enclosure, weight, power requirements, and included accessories.
Contact information for technical assistance and product inquiries.
Information on obtaining warranty service and returning products.
To Next Page
