Keychron K1 Max - Bluetooth Device Management; Wired Mode and Power Off

18
4. Search for the Bluetooth device “Keychron K1 Max” on your device and connect it (the Bluetooth
indicator goes off aer successful pairing).
Note: This keyboard supports pairing up to 3 devices simultaneously via key combinaon “fn” + “1” /
“fn” + “2” / “fn” + “3”.
*The Bluetooth indicator will connue to flash for 3 minutes.
**Slow or failed connecons may exist due to different Bluetooth versions, please make sure all the
sengs are correct.
Short press key combinaon “fn” + “1” / “fn” + “2” / “fn” + “3” to switch to other device.
TURN OFF THE KEYBOARD
Switch the keyboard to the Cable opon and unplug the power cable.
RECONNECT:
1. Switch the keyboard to the Bluetooth opon to acvate the keyboard.
2. The Bluetooth indicator flashes for 3 seconds and automacally pairs with the last paired device.
3. If the Bluetooth indicator is off, press any buon to enter the connecon again.
*The keyboard must have been paired with the device to perform this funcon.
1. Switch the toggle switch to the Cable opon.
2. Connect our cable with your PC and keyboard.
3. Backlighng will be turned on.
*Under Wired Mode, keyboard will not enter into Baery Saver Mode.