9
Watch The Building Tutorial On Our Website
9
Factory Reset
10
If you are building the keyboard for the first time, we highly
recommend you watch the building tutorial video on our
website first, then start building the keyboard yourself.
① Plug in the power cable and switch the keyboard to Cable mode.
② Factory reset the keyboard by pressing fn + J + Z (for 4 seconds).
③ Download the right firmware and QMK Toolbox from our website.
④ Switch the keyboard to OFF mode and remove the space bar keycap
to find the reset button on the PCB.
⑤ Hold the reset key first, then switch the keyboard to Cable mode.
Release the reset key, and the keyboard will now enter DFU mode.
⑥ Flash the firmware with the QMK Toolbox.
⑦ Factory reset the keyboard again by pressing fn + J + Z (for 4 seconds).
Troubleshooting? Don’t know what’s going on with the keyboard?
Step by step guide can be found on our website.
To Next Page
Loading...
