05
After connecting the fourth
Joint, connect it vertically
with to the third Joint.
1.Peel off the blue cover.
5.Fit apparatus into the
gray base.
6.Construct shell. 7.Rotate shell firmly.
2.Stick the base mount onto a smooth surface and press
down firmly. Make sure your desk is smooth and clean, and
there are no obstacles in 30cm radius.
*Tips: it is recommended leave the sticker for 10 mins after
firmly applied to a surface.
3.Rotate shell and detach
all 4 parts.
4.Put one Joint in the mount and make sure direction is
correct.
30cm
05
Bac is done!
To Next Page
Loading...
