Keystone G220 - User Manual

INSTRUCTIONS FOR Radio Control Operator
Single entry transmitter G220
Read the following instructions thoroughly before using the remote.
This transmitter must be adjusted so that the coding switches match the coding on your present operating
transmitters or receiver
FCC Regulations: This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Programming Remote Controller to the Opener
1. Remove the Transmitter Cover
Remove the access cover from the front of the transmitter by sliding the cover
away from the top of the transmitter (Figure A). This will expose the battery
and the dip switches. The code can now be changed using a small screwdriver.
2. Setting the codes
You may set your transmitter to any code you desire, but be sure the code you
set matches both your transmitter and receiver.
There are twelve (12) dip switches, each of which can be placed in two
different positions (+,-). DO NOT set all switches in the same position, such as
all +, all -, (Figure B). WARNING: No other adjustments should be made
inside the transmitter.
3. Terminal block for 9 dip switches receiver
For some receivers which only have 9 dip Switches, it will be necessary for
you to move the small black code terminal (Open the housing with cross-shaped screwdriver (Figure C) to
find terminal block (Figure D) ) to PINS in the middle and 9 .Therefore, the code selection of the 9 dip
switches receiver model and the dip switches on your transmitter 1 thru 9 should be set exactly the same.
The same as those on your receiver, switches 10, 11,12 on the transmitter should be set in the off position.
Open the housing with cross-shaped screwdriver
Figure C
Slider the cover for
battery replacement
Battery Type: 23A
Figure A
Figure B

Summary

FCC Regulations

Programming Remote Controller to the Opener

Remove Transmitter Cover

Remove the access cover from the transmitter's front by sliding it away from the top to expose the battery and dip switches.

Setting the Codes

Set your transmitter code to match your receiver's code using the 12 dip switches (+,-). Do not set all switches identically.

Terminal Block for 9 Dip Switches Receiver

For 9 dip switch receivers, move the black terminal to PINS in the middle and 9. Set transmitter switches 1-9 to match receiver.

Warning

Safety Precautions for Garage Door Operation

Keep remotes from children, monitor operation, never allow passage during movement, and avoid unauthorized modifications.

Keystone G220 Specifications

General

Brand	Keystone
Model	G220
Category	Transmitter
Language	English