Programming an RFID credential into Keysy:
1. Hold down the desired button to program for 6 seconds.
2. After 6 seconds the red LED will begin blinking, release the button.
3. Place the Keysy antenna (behind the LED) in the center of the card/keyfob.
4. Gently move it around until the LED turns green. Keysy is now programmed.
5. After 15 seconds if no valid ID is read the LED will turn amber. If this happens flip the card/keyfob
over and repeat steps 1-4 on the other side.
6. If card fails to read after multiple attempts it may be unsupported. Feel free to email
info@tinylabs.io with an image of the device for support.
Using Keysy:
1. Press and release the previously programmed button, the LED will flash green to indicate a valid ID
is stored.
2. Hold Keysy in front of the RFID reader. The reader should beep or blink indicating a valid ID has
been read. That's it!
Copying a previously read ID onto a Keysy rewritable keyfob:
1. Hold Keysy against the rewritable keyfob, aligning the LED in the center of the rewritable keyfob.
2. Press the button containing the desired ID 5 times while holding in front of the rewritable keyfob.
3. After a short delay Keysy will either blink green (success) or red (failure) 3 times.
4. If programming failed flip over the rewritable keyfob and repeat steps 1-3.
5. After being programmed the keyfob can be used just like the original and requires no battery.
6. Additional rewritable keyfobs are available for purchase at http://tinylabs.io/keysy
Note:
Keysy consumes very little power when emulating RFID and while in an idle state. However, when
programming Keysy or rewritable keyfobs a large amount of power is required. It is recommended to
only program with a fresh CR2032 battery. If programming fails and the battery is not fresh, replace the
battery and retry the programming sequence.
For assistance please email info@tinylabs.io.
Copyright Tiny Labs Inc. 2017
To Next Page
Loading...