Keytrak ActiveLot - Page 2

ActiveLot OBD Module User’s Guide
2 Confidential & Proprietary Information of KeyTrak, Inc. © 2014
Procedure
WARNING! Do not insert or remove the OBD module from the vehicle’s OBD-II port
while the vehicle is running.
1. Locate your vehicle’s 16-pin OBD-II port.
2. Insert the OBD module into the OBD-II port on your vehicle.
3. Start the vehicle. This is required to pull the VIN (vehicle identification number) from the
vehicle’s computer system.
4. You can verify the unit is transmitting using the ActiveLot iOS app, the Web app, or the
KeyTrak application.
NOTE: A couple of minutes after installation, the OBD module will acquire the
necessary GPS satellite information to provide an accurate location.