KFI 100560 User Manual

1
(G)
“Figure 2” Remove Side Screws
Mounting Bracket
“Figure 3” Install Winch Mounting Plate
(A)
(B)
(C)
(D)
(E)
“Figure 1”
Polaris RANGER
Winch Mount
Winch Mount PART # 100560
Kit Components:
Qty
Part Description
1……………. Winch Mount mounting channel
1……………. Winch Mount fairlead bracket
6……………. 5/16 x 1” Hex Head Flange Bolts
6……………. 5/16” SAE Flat Washers
6……………. 5/16” Nylock Nuts
1……………. Hardware Kit (Mini-Rocker Switch)
INSTALLATION INSTRUCTIONS:
1. Using a torx bit, remove both the small (A)
and large (B) grills that are attached to the
bumper.
2. Using a torx bit, remove the six torx
screws (G) that hold the side plastic
radiator shrouds to the bumper.
3. Using a flat screwdriver, remove the two
plastic fasteners from the bumper tabs (E).
4. Remove the three lower bumper bolts (D).
5. Remove the two top bumper bolts (C).
6. Install the winch mounting plate into
location as shown in “Figure 3” using the
supplied 5/16” hardware. Note: If looking at
the front of the bumper the slots will need to be
towards the back and flanges down.
7.
Assemble your fairlead to the fairlead
bracket and then assemble your winch and
the fairlead bracket assembly into location
as shown in “Figure 4” to the Mounting
plate using the hardware supplied with
your winch.
Note: If you are installing a Warn
4.0 you will need to use the fairlead bracket that
comes with that winch kit and discard the one
included.
SLOTS TO
THE BACK

KFI 100560 Specifications

General

Brand	KFI
Model	100560
Category	Racks & Stands
Language	English

Summary

Winch Mount Installation Guide

Kit Components Overview

Lists all parts included in the Polaris Ranger winch mount kit, such as mounting channel and hardware.

Bumper Preparation for Installation

Instructions for removing grills, side shrouds, and bumper bolts to prepare for winch mount.

Mounting Plate and Fairlead Assembly

Steps to install the winch mounting plate and attach the fairlead bracket with winch.

Wiring and Final Reassembly

Connecting winch motor wires and reattaching bumper components after installation.

Additional Information and Switch Mounting

General Notes on Variations

Mentions that some machines may vary from pictures due to different Ranger series.

Optional Contactor Location

Reference to Figure 5 for the optional contactor location on the vehicle.

Mini-Rocker Switch Mounting

Guidance on mounting the handlebar-mounted switch to any desired location using hardware.

Corded Switch Plug-in Receptacle

Shows the location for mounting a corded switch's plug-in receptacle, pre-marked on the plastic.

Ignition Wire Connection

Instructions on connecting the remote/switch red wire to the ignition switch's red/white wire.