4
Introduction
Avoid installing the equipment in a place subject to frequent vibration or
in an unstable place.
Avoid installing the equipment in a place where vibration is directly transmitted to it or in an
unstable place such as a wobbly place. Otherwise, the equipment may fall, causing personal
injury.
Avoid plugging up the vent holes.
Avoid plugging up the vent holes of the equipment. Otherwise, the internal heat does not
dissipate, and the resulting temperature rise may cause fire.
Noisy place
It may be impossible to hear an alarm buzzer sound, etc. Therefore, a response to an
emergency situation may delay.
Place exposed to intense electromagnetic noise from other nearby
equipment
Avoid welding work within 10 m from the equipment. Avoid tying the power cable and other
power lines together in a bundle. Insulate the printhead to avoid direct contact with the conveyor,
etc. Otherwise, a malfunction may occur.
Place in a corrosive gas atmosphere such as acid
Place where ambient temperature and relative humidity are outside the
ranges of 0 to 40°C* and 10 to 85% RH (no-condensing) respectively
* 10 to 40°C depending on the type of ink
Be sure to establish a ground.
Establish a Class D ground.
Place exposed to intense electromagnetic noise from other nearby
equipment
Avoid welding work within 10 m from the equipment.
Otherwise, a malfunction may occur.
Insulation of the photocell sensor
If the photocell sensor is provided with a metal case, insulate it from the conveyor, etc. using
plastic fittings.
Insulation of the printhead
Insulate the printhead to avoid direct contact with the conveyor, etc.
To Next Page