Integration instructions for host product manufacturers according to KDB 996369 D03 OEM
Manual v01
2.2 List of applicable FCC rules
CFR 47 FCC PART 15 SUBPART C has been investigated. It is applicable to the modular transmitter
2.3 Specific operational use conditions
This module is stand-alone modular. If the end product will involve the Multiple simultaneously transmitting condition or different
operational conditions for a stand-alone modular transmitter in a host, host manufacturer have to consult with module
manufacturer for the installation method in end system.
2.4 Limited module procedures
Not applicable
2.5 Trace antenna designs
Not applicable
2.6 RF exposure considerations
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should
be installed and operated with minimum distance 20cm between the radiator & your body.
2.7 Antennas
This radio transmitter FCC ID:2A8Q4-EDGE2 has been approved by Federal Communications Commission to operate with
the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a
gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device.
Antenna No. Operate frequency band Antenna Type Maximum antenna gain
Antenna 0
2400-2500MHz
5000-6000MHz
FPC Antenna
3.45dBi For 2.4GWIFI
1.1dBi For 5.2GWIFI
1.54dBi For 5.8GWIFI
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following" Contains FCC ID:2A8Q4-EDGE2 ".
2.9 Information on test modes and additional testing requirements
Host manufacturer which install this modular with single modular approval should perform the test of radiated emission and
spurious emission according to FCC part 15C:15.247/FCC part 15E:15.407 and 15.209 requirement, only if the test result
comply with FCC part 15.247/FCC part 15E:15.407 and 15.209 requirement, then the host can be sold legally.
2.10 Additional testing, Part 15 Subpart B disclaimer
Host manufacturer is responsible for compliance of the host system with module installed with all other applicable
requirements for the system such as Part 15 B.
Antenna 1
2400-2500MHz
5000-6000MHz
FPC Antenna
3.45dBi For 2.4GWIFI
1.1dBi For 5.2GWIFI
1.54dBi For 5.8GWIFI
To Previous Page
Loading...
