Knowing your vehicle
183
Automatic window reversal (When
window is closed by the automatic
power window)
If the upward movement of the win-
dow is blocked by an object or part of
the body, the window will detect the
resistance and will stop upward
movement. The window will then
lower approximately 30cm (11.8 in)
from the top to allow the object to be
cleared.
If the automatic power window sys-
tem does not operate properly, you
may reset as follows:
1. Turn the ignition key to ON posi-
tion.
2. Close each window and continue
pulling up on each power window
switch for at least 0.5 second after
the window is completely closed.
OED036087/H
WARNING
• The automatic window reversal
feature will only operate when
the automatic power window
operation feature is used.
Automatic window reversal will
not operate if the window is
raised using the first detent
position (5) on the power win-
dow switch. Always double
check to make sure all faces,
arms, hands and other obstruc-
tions are safely out of the way
of before operating the power
window.
• If an object less than 4 mm in
diameter is caught between the
window glass and the upper
window channel, the automatic
reversal may not detect the
resistance and will not operate.
Therefore, always check for any
obstructions before raising any
window.
To Next Page
Loading...
