347
Knowing your vehicle
Installing a child restraint system by
lap/shoulder belt (on the rear seat)
To install a child restraint system on
the rear seats, do the following:
1. Place the child restraint system in
the desired position.
2. Extend the shoulder/lap belt from
its retractor.
3. Route the lap/shoulder belt
through the restraint according to
the seat manufacturer’s instruc-
tions.
4. Buckle the seat belt and allow the
seat belt to take up any slack. After
installation of the child restraint
system, try to move it in all direc-
tions to be sure the child restraint
system is securely installed.
If you need to tighten the belt, pull
more webbing toward the retractor.
E2MS103005
MMSA3030
E2BLD310
To Next Page
