15
7
7
What to do in an emergency If you have a flat tire (with Tire Mobility Kit)
3. Make sure the compressor valve on
the filling hose is locked.
4. Unscrew the valve cap from the valve
of the defective tire and screw the fill
-
ing hose of the sealant bottle onto the
tire valve.
Securely install the sealant filling hose
on the valve. If not, sealant may flow
backward, possibly clogging the filling
hose.
5. Ensure that the compressor is
switched off, position 0.
6. Connect between compressor and the
vehicle power outlet using the cable
and connectors.
7. Make the EV button position on or
ignition switch position on.
8. Switch on the compressor and let it
run for approximately 5 ~ 7 minutes
to fill the sealant up to proper pres
-
sure. (refer to "Tires and wheels" on
page 9-5). The inflation pressure of
the tire after filling is unimportant and
will be checked/corrected later. Be
careful not to overinflate the tire and
stay away from the tire when filling it.
When the tire and wheel are dam
-
aged, do not use Tire Mobility Kit for
your safety.
If the tire pressure is below
26psi(180kPa), do not drive the vehicle.
The tire may cause accident.
9. Switch off the compressor.
10.Detach the sealant filling hoses from
the sealant bottle connector and from
the tire valve. After using, leave the
sealant bottle and the compressor
attached together.
Return the TMK to its storage location in
the vehicle.
Carbon monoxide
Do not leave your vehicle running in a
poorly ventilated area for extended peri
-
ods of time. Carbon monoxide poisoning
and suffocation can occur.
Distributing the sealant
After putting sealant into the tire, it is
necessary to drive the vehicle so that the
sealant becomes evenly distributed
inside the tire.
To Next Page
Loading...
Need help?
General
