Kia niro ev Owner's Manual

29
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFETY WARNINGS. *IF EQUIPPED †LEGAL DISCLAIMERS ON BACK INSIDE COVER
(Type B shown)
(Distances are approximate and vary
depending on vehicle speed)
(Actual screen on vehicle may vary)
The SCC system is a supplemental system and is not a substitute for safe driving. It is the
responsibility of the driver to always check the speed and distance to the vehicle ahead.
STEERING WHEEL CONTROLS
Smart Cruise Control
with Stop & Go Video
To view a video on your
mobile device, snap this
QR Code or visit the listed
website.
Refer to page 2 for more
information.
www.youtube.com/KiaFeatureVideos
QR CODE
Smart Cruise Control
canceled
F
E
H
A
B
D
172ft 130ft
82ft
106ft
C
G
Smart Cruise Control (SCC) with Stop & Go*
†7,21
The Smart Cruise Control (SCC) system allows you to set the vehicle to maintain a constant speed
and predetermined distance so long as it is not limited by traffic. When traffic is encountered, the
vehicle may be slowed to help maintain the set distance from vehicles detected ahead without the
driver depressing the brake pedal.
To set/adjust SCC speed:
• Push the CRUISE button
A
to turn system ON. The CRUISE indicator will illuminate
on the instrument cluster
• Accelerate/decelerate to the desired speed
• Press button
B
down to set the speed. Press the RES+/SET- button
B
up/down to
increase/decrease the set speed
To adjust the vehicle-to-vehicle distance setting
C
: Press the SCC button
D
on the steering
wheel. The images on the LCD screen
E
and the Instrument Cluster
F
will change when scrolling
through the settings. Each time the button is pressed, the vehicle-to-vehicle distance changes.
To cancel SCC operation: Press the CANCEL button
G
or press the brake pedal. The LCD
screen will display a message that the SCC operation is canceled
H
.
To turn SCC system OFF: Press the CRUISE button
A
. The CRUISE indicator on the instrument
cluster will turn OFF.
• To change the Cruise Control mode from SCC to
standard Cruise Control, press and hold button
D
.
Repeat to switch modes again (The SCC system must
not be activated to change modes)
• For the SCC system to operate, you must be traveling
at a minimum speed of 20 mph, when no vehicle is
detected in front
• When following a vehicle, the system is able to
automatically adjust your cruise speed based on the
vehicle detected in front
QUICK TIPS
REMINDERS:
• In standard Cruise Control, the driver needs to manually assess the distance from
other vehicles as the system will not apply brakes to slow down the vehicle
• SCC system is activated when ignition is turned on. Speed will need to be reset when
ignition is cycled on
• The distance settings are approximations and may vary depending on speed and
factory settings at the time. See owner’s manual for more information
• The SCC is also canceled when the driver’s door is opened, Rotary Dial Shifter Knob
is changed out of D (Drive) and various other conditions. See owner’s manual for
other conditions
• If the SCC system is left on, it can be activated inadvertently. Keep the system off
when not in use to avoid setting a speed which the driver is not aware of

Kia niro ev Specifications

General

Brand	Kia
Model	niro ev
Category	Automobile
Language	English