Maintenance
968
Light bulbs
Headlamp (Low/High beam) bulb
replacement (Headlamp Type A)
1. Open the bonnet.
2. Remove the headlamp bulb cover
by turning it counterclockwise.
3. Disconnect the headlamp bulb
socket-connector.
4. Unsnap the headlamp bulb retain
-
ing wire by pressing the end and
pushing it upward.
5. Remove the bulb from the head
lamp assembly
6. Install a new headlamp bulb and
snap the headlamp bulb retaining
wire into position by aligning the
wire with the groove on the bulb.
7. Connect the headlamp bulb
socket-connector.
8. Install the headlamp bulb cover by
turning it clockwise.
Headlamp bulb
Halogen bulbs
䳜 Halogen bulbs contain pressurized
gas that will produce flying pieces
of glass if broken.
䳜 Always handle them carefully, and
avoid scratches and abrasions. If
the bulbs are lit, avoid contact
with liquids. Never touch the glass
with bare hands. Residual oil may
cause the bulb to overheat and
burst when lit.
A bulb should be operated only
when installed in a headlight.
䳜 If a bulb becomes damaged or
cracked, replace it immediately
and carefully dispose of it.
䳜 Wear eye protection when chang
-
ing a bulb. Allow the bulb to cool
down before handling it.
To Next Page
Loading...
Need help?
General
