15
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFETY WARNINGS. *IF EQUIPPED †LEGAL DISCLAIMERS ON BACK INSIDE COVER
Headlight position
Parking light position
AUTO
Auto Light* / HBA*
OFF
OFF position
It may be helpful to pull/push the bottom of the
Steering Wheel towards/away from you to adjust the
desired distance prior to adjusting the angle.
QUICK TIP
REMINDERS:
• HBA will operate when vehicle speed exceeds 25 mph
• If the lever is pushed away from you while HBA is operational, HBA will turn off and the high beams will be on continuously.
If the lever is pulled toward you while HBA is operational, HBA will turn off
• If the light switch is switched to the headlight position, HBA will turn off and low beams will be on continuously
Tilt/Telescoping Steering Wheel
†25
To adjust the Steering Wheel, press the Lock-
Release Lever
A
down and adjust
B
to the
desired angle and
C
distance.
When finished, pull the Lock-Release Lever
A
up to lock the Steering Wheel in place.
Headlights & High Beams
To operate:
• Rotate the switch to change
the Headlight function
• Push the lever to turn High Beams ON
• Pull the lever to flash Headlights /
High Beams
AUTO Light function* — When the light switch is in the AUTO Light position, the tail lights and
headlights will turn ON/OFF automatically depending on the amount of light outside the vehicle.
High Beam Assist (HBA)* — The High Beam Assist is designed to automatically adjust the headlight
range by switching between high and low beams based on light detected from oncoming vehicles and
road conditions.
To enable HBA, toggle the light switch to the AUTO Light position and turn on the high beams by
pushing the lever away from you. The High Beam Assist indicator
will illuminate.
Refer to section 4 in the Owner’s Manual for more information.
Refer to section 4 in the Owner’s Manual for more information.
A
B
C
STEERING WHEEL CONTROLS
To Next Page
Loading...
