29
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFETY WARNINGS.
*IF EQUIPPED
Your Automatic Climate Control
system may differ from those in the
illustrations.
Refer to section 4 in the Owner’s
Manual for more information.
Automatic Climate Control* (Continued)
Climate Control Auto Function
1. Press AUTO
B
to select Full Auto Operation. The Auto setting
automatically controls the airflow modes, fan speeds, air intake and
air conditioning according to the temperature setting selected
2. Set desired Temperature
A
3. Press SYNC
E
to select Sync Temperature Control operation, which
synchronizes the passenger’s temperature to the driver’s setting
Defrost Outside Windshield:
1. Set Fan Speed
F
to the highest position
2. Set Temperature
A
to Hot
3. Press the Front Defrost button
L
Defog Inside Windshield:
1. Set Front Fan Speed
F
to the highest position
2. Set Temperature
A
to the highest position
3. Press the Front Defrost button
L
• Defrost Mode activates A/C and opens Fresh Air Vent to help
dehumidify the air and improve Defroster performance
• During Auto Operation, the A/C indicator will NOT illuminate. The fan
speed, air intake, air flow and air conditioning may automatically be
engaged at any time to reach the desired temperature and reduce
humidity
• Keep the inside glass as clean as possible to reduce window fogging
QUICK TIPS
Face-Level
Bi-Level
Floor-Level
Floor/Defrost-Level
REMINDERS:
• Pressing any button during AUTO operation will deactivate
the AUTO function and switch to manual mode, except for
Temperature Control
• When in AUTO mode, Air Flow Mode and Fan Speed do not
display on the Climate Control Display
• Cold or warm ambient air may flow in through vents if
Recirculated Air button is not pressed ON (LED lit)
Auto Defogging System
Video
To view a video on your
mobile device, snap this
QR Code or visit the listed
website.
Refer to page 2 for more
information.
QR CODE
www.youtube.com/KiaFeatureVideos
Auto Defogging System
Auto defogging is designed to reduce the fogging
up of the inside of the windshield by automatically
sensing the moisture of the inside of the
windshield. The system will automatically
change to defrost mode when needed.
Auto Defogging is set ON by default. To cancel
Auto Defogging, press the Front Defrost button
for three seconds when the ignition is in on (ADS
OFF icon will illuminate). To turn Auto Defogging
on again, press the Front Defrost button
for
three seconds.
Air Flow Modes
To select Air Flow Modes, press the MODE button
H
to cycle through to desired mode:
CENTER PANEL
To Next Page
Loading...
