Features of your vehicle
1505
Wipers and washers
occur and may not be covered by
your vehicle warranty.
䳜 When starting the vehicle in win
-
ter, set the wiper switch in the
OFF (0) position. Otherwise, wip
-
ers may operate and ice may
damage the windscreen wiper
blades. Always remove all snow
and ice and defrost the
windscreen properly prior to
operating the windscreen wipers.
䳜 When tinting the windscreen, be
careful of any fluid getting into
the sensor located in the top
centre of the front windscreen. It
may damage the related parts.
Operating windscreen washers
Type A
Type B
1. Move the wiper speed control
switch to In OFF (0) position.
2. Pull the lever gently toward you
to spray washer fluid on the
windscreen and to run the wipers
1-3 cycles. Use this function
when the windscreen is dirty. The
spray and wiper operation will
continue until you release the
lever.
If the washer does not work, check
the washer fluid level. If the fluid
level is not sufficient, you will need
to add appropriate non-abrasive
windscreen washer fluid to the
washer reservoir.
The reservoir filler neck is located in
the front of the engine compart
-
ment on the driver side.
To prevent possible damage to the
washer pump, do not operate the
washer when the fluid reservoir is
empty.
Do not use the washer in freezing
temperatures without first warming
the windscreen with the defrosters;
the washer solution could freeze on
the windscreen and obscure your
vision.
䳜 To prevent possible damage to
the wipers or windscreen, do not
To Next Page
Loading...
Need help?
General
