14
14
DLIGHTING.COM
Learn Switch:
If you do not want to use the code
set up by manufacturer or the fan
doesn’t work, then you will need
to use the set up procedures
listed below:
Install and restore power to the
fan, press and hold the “Learn
Switch” for 3 seconds until the fan
runs at medium speed, then the
setting process is completed.
NOTE: You must press the “Learn
Switch” within 30 seconds after
restoring power the fan.
Remarks: The initial power-on
state is FAN OFF.
J
1 x 23A 12V
Battery
(Not Supplied)
To Next Page
Loading...
