7
18. Route subwoofer harness from passenger’s
side to driver’s side under carpet.
Subwoofer harness should be routed
behind seat brackets. Routing from one
precut opening to the next will aid in
harness routing. Fig. 18
19. Route the black four pin subwoofer connector out of the hole that was cut near the stud where
the jack tools attach. Route the white amplifier connector behind seat bolts and out of the hole
that was cut near outer seat bolt. Fig. 19
NOTE: Some subwoofers may be
shipped with an additional 12-inch
adaptor harness connected to the
subwoofer amplifier. If so, tuck the
additional harness underneath the
carpet as well while positioning the
subwoofer into location.
20. Make wire harness connections to
subwoofer and amplifier and set subwoofer
in place aligning brackets with the stud and
seat bolt hole. Fig. 17
NOTE: If equipped with the optional
rear rubber floor liner, use the
subwoofer enclosure as a template to
mark the liner around the outside edge
of the subwoofer enclosure. Using a
razor knife or shears, remove the
portion of the rubber floor liner directly
below the subwoofer enclosure.
21. Reinstall the jack tool bag and nut.
NOTE: MAKE SURE WIRE HARNESS IS NOT BEING CRUSHED UNDER JACK
TOOL BAG!
Fig. 19
Fig. 17
Fig. 18
To Next Page
Loading...
