To Next PageTo Next Page
Need help?Do you have a question about the Kicker Front Row ZXDSP1 and is the answer not in the manual?
Instructions for physically mounting the device and connecting wiring.
Diagram and explanation for common wiring configurations.
Explanation of input selection switches for channels.
Modes for powering the unit on automatically via +12V or DC Offset.
Adjusting input levels and understanding clip indicators for optimal signal.
Adjusting crossover frequencies, slopes, and multipliers for audio filtering.
Setting the low-frequency cutoff for the subwoofer to protect speakers.
Setting output levels to amplifiers for optimal volume and clarity.
Adjusting time alignment for left channels to create a stereo image.
Using SHOCwave and KickEQ for bass frequency restoration and boost.
Enabling or disabling the surround sound effect for rear channels.
Wiring setup for driving tweeters, mids, and subs separately with active crossovers.
Wiring for mid-range, mid-bass, and subwoofers with specific band-pass filters.
Steps to mount the remote control bracket and connect it via RJ-45 cable.
Steps to diagnose no audio output with green LED off or on.
Resolving low output, alternator whine, and ground loop noise problems.
General| Type | Digital Signal Processor |
|---|---|
| Channels | 8 |
| Crossover Types | High-pass, Low-pass, Band-pass |
| EQ Bands | 31 |
| Time Alignment | Yes |
| Input Voltage | 9V - 16V |
| Equalization | Parametric |
| Crossover Slope | 6dB/octave to 48dB/octave |
