3
Possible locations for KM
Coaxial Speaker Mounting
Mounted in the Bow
Mounted
Mid-Ship
Stern
Mounted
INSTA
LLATION
Mounting: Make sure the stainless steel mounting screws and U-type speed clips will not puncture the
fuel cell, wiring, or interfere with any mechanical parts on the underside of the mounting surface. Pre-drill
the mounting screw holes using a 7/64” (2.5mm) bit, and attach the KM coaxial speakers to the boat
by fastening the supplied stainless steel coarse-threaded screws to the boat’s structure. If applicable,
use the enclosed stainless steel U-type speed clips. If the supplied hardware is not applicable to your
installation, some other means of securely attaching the speakers to the boat must be used.
Wiring: Carefully place the speaker wire in a location that is clear of standing water and moving
components of the boat. Connect the speaker wire to the speaker terminals.
+–
2018 45KM604 Coax Rev D.indd 32018 45KM604 Coax Rev D.indd 3 4/18/2018 2:34:29 PM4/18/2018 2:34:29 PM
To Next Page
Loading...
