2
The KICKER KM coaxial speakers are specifi cally designed for mounting in free-air applications. The
speakers do not require a sealed enclosure for optimum performance. It is important to isolate the sound
coming off the front of the driver from the sound radiating from the back of the driver. This isolation is
usually accomplished by using the driver in a factory speaker location, or in a location with a semi-isolated
rear chamber.
SPECIFICATIONS
Authorized KICKER Dealer:
Purchase Date:
Speaker Model Number:
LOCATION
The sound produced by the KM coaxials is directional. Find the best location for stereophonic sound. If
necessary, add more KM coaxial speakers to the system to help distribute and balance the sound-stage.
After determining the best mounting locations, carefully check the areas where the mounting hardware will
be placed.
Model: KM60
Woofer [in, mm] 6-1/2, 165
Tweeter [in,mm] 1/2, 13
Rated Impedance [Ω] 4
Peak Power Handling [ Watts] 150
Continuous Power Handling [Watts RMS] 50
Sensitivity [1W, 1m] 90
Frequency Response [Hz] 35-21k
Mounting Hole Diameter [in, mm] 5-3/16, 132
Mounting Depth [in, mm] 2-1/2, 64
Grilles Yes
Tweeter Magnet Material Neodymium
Tweeter Dome Material PEI
Tweeter Design Balanced Dome
Woofer Cone Material Polypropylene
Woofer Surround Material Santoprene
KM Coaxial Speakers
Owner’s Manual
IMPORTANT SAFETY WARNING
Prolonged continuous operation of an amplifi er, speaker, or subwoofer in a distorted, clipped or over-
powered manner can cause your audio system to overheat, possibly catching fi re and resulting in serious
damage to your components and/or vehicle. Amplifi ers require up to 4 inches (10cm) open ventilation.
Subwoofers should be mounted with at least 1 inch (2.5cm) clearance between the front of the speaker and
any surface.
2018 45KM604 Coax Rev D.indd 22018 45KM604 Coax Rev D.indd 2 4/18/2018 2:34:29 PM4/18/2018 2:34:29 PM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
