To Next PageTo Next Page
Need help?Do you have a question about the Kicker PXA200.1 and is the answer not in the manual?
Primary language guide for Kicker PXA amplifiers, covering models PXA200.1 and PXA500.1.
Detailed performance metrics including RMS power, dimensions, frequency response, and impedance.
Critical safety information regarding amplifier operation, potential hazards, and system damage.
Guidance on securely mounting the amplifier and connecting power, ground, and speaker wires.
Visual schematics illustrating the proper connection of power, speaker, and remote turn-on.
Explanation of automatic turn-on modes (+12V, DC Offset) and input signal level selection.
Instructions for setting the low-pass filter, bass boost, and input gain controls.
Information on connecting and using the optional remote bass controller for level adjustment.
Diagnosing issues based on Power Protection LED status (Red/Blue) and lack of audio output.
Solutions for common problems like noise, overheating, low output, and protection mode activation.
Details on what the two-year limited warranty covers and what is specifically excluded.
Steps for obtaining warranty service, including contacting dealers and obtaining an RMA number.
Instructions for international customers to contact dealers for country-specific warranty policies.
Warning about Kicker products producing sound levels that can cause permanent hearing damage.
General| RMS Power at 1 Ohm | 200 Watts |
|---|---|
| Frequency Response | 20 Hz - 20 kHz |
| Signal to Noise Ratio | > 95 dB |
| Input Sensitivity | 200 mV - 4 V |
| Bass Boost | 0 - 18 dB at 40 Hz |
| Crossover Type | Low-pass |
| RMS Power at 2 Ohms | 200W |
| Crossover | Variable Lo-pass 50-200 Hz |
