Place Hyper Flyer on smooth ground surface, (asphalt, blacktop, etc.). Avoid grass or other rough
surfaces. Push throttle joystick on transmitter fully forward to reach take off speed. Hyper Flyer
will start to slide forward on ground. Be sure that it is moving directly into the wind direction.
Hyper Flyer will take off after moving approx. 30 feet (Minimum take off room should be 35 feet).
Guide Hyper Flyer straight for several seconds before attempting any maneuvers.
Steering Joystick
Steering
Joystick
Steering
Joystick
Throttle
Joystick
Pull back on steering joystick to
raise elevator to “up” position for
a loop
TapTap
Shift both joysticks (throttle and steering) simultaneously for desired flight patterns
When Hyper Flyer has achieved 50 ft. altitude (approx.), you can shut your propellors
down by allowing the throttle joystick to move all the way back to “OFF” position. Hyper Flyer
can then steer right or left by “tapping” the steering joystick. Allowing Hyper Flyer to
glide in this manner will extend flight times significantly.
Ground Launch
Gliding
To Next Page
Loading...