9
Installation
Alarm Tamper-Resist Feature
• A tamper resist feature has been provided. To activate
this feature you must break out the tamper-resist
blocks on the mounting plate (Figure 4A). Use a small
screwdriver.
• Using this feature will deter children and others from
removing the alarm from the mounting plate.
• The tamper-resist tab will have to be released in order
to change the battery. Using a tool (small screwdriver)
push the tab away from the mounting plate (Figure 4B)
and rotate the alarm clockwise in the “OFF” direction.
• After installation, test the alarm by depressing and
holding down the Test/Hush button for several
seconds. This should sound the alarm.
BREAK
OUT
Figure 4A Figure 4B
0301-7230-01(135993)_2021.qxd:_ 2021.9.15 10:54 AM Page 10
To Next Page
Loading...
