Installation
12
• If you are mounting the alarm in plaster board or drywall,
drill a 5 mm (3/16") hole into the wall and insert the
plastic anchors provided into the wall or wall anchors
until the screw head is approximately 3 mm (1/8") from
the wall.
• Hook the unit over the screw head and into the keyhole
in back of the unit.
• Plug the cord into an electrical outlet.
Tabletop
You can also use your alarm as a tabletop unit. Simply follow
the above steps for removing adaptor, then instead of
mounting to a wall, simply pull out slide support and stand
on table, bedside stand, chest of drawers, etc. (refer to
diagram on Page 4).
Battery Installation
Install the battery by first removing the battery door and the
battery pack. Align the connector with the slot in the
battery. Insure the orientation of the two alignment ribs
align with the slot in the battery. (Red dot on battery will
align with red wire). Press the connector in until it is fully
seated. See drawing below. Be sure to correctly insert
battery into the battery compartment, as shown in drawing
below. After inserting battery, replace back door.
Warning: Do not use any other type of rechargeable battery
in your alarm or attempt to recharge the battery pack
yourself. Improper charging may even cause the battery
pack to overheat or leak, thus posing possible injury to the
user.
To Next Page
Loading...
Need help?
General
