When the support leg (F) is folded in, the power circuit is interrupted. The
electronics switches off automatically.
The last step is to pull the funnel guides (M) from the metal anchors.
6. Adjusting the carriage
The carriage (C) on the top of the platform (A) can be slid forwards and back-
wards. The carriage (C) can be freely slid backwards when a kiddy child
safety car seat is installed on the platform.
If you want to move the carriage (C) forward, you must pull both side carria-
ge levers (K) upwards (Fig. 11, No. 1) and simultaneously move the carriage
(C) forward (Fig. 11, No. 2).
7. What to do in case of malfunctioning electronics?
The child safety car seat cannot be released electronically or the sound
signals do not function:
A: Open the battery compartment lid (D) and check whether the batteries are
inserted correctly.
B: Reset the electronics by retracting the support base (G) and then comple-
tely folding the support leg (F) into the platform (A) and out again. Now
restart the electronics.
C: The batteries are flat or have discharged! Insert 8 new AAA batteries and
make sure of correct polarisation.
8
ENG
To Next Page
Loading...
